Installation guide

Web Admin Interface Settings for XMPP
Acano solution: Single combined Acano server Deployment Guide R1.6 76-1054-01-H
Page 44
4. Log in to the Web Admin Interface and configure the XMPP server settings as follows:
a. Go to Configuration > General
b. Configure the XMPP Server Settings section using the domain, component and secret
set up earlier. The Unique Call Bridge name is the component name set up previously
(without a domain suffix). The Server Address is the IP address or hostname of the
XMPP server, with an optional :<port> (default is 5223).
Note: Authentication Proxy component and Authentication suffix which were used in release
1.2 and earlier, are no longer required.
c. Select Submit at the bottom of this page.
5. Go to Status > General and verify the server connection.
You should see details similar to the following in the XMPP Connection field:
6. On a PC, install the Acano PC Client from:
https://clientupgrade.acano.com/download/oBklj0sd28dl2mz/AcanoClient.application
Log in to the Acano PC Client using one of the newly created user accounts. Then check
that you can make calls as expected.