Installation guide

Dial Plan Configuration – Integrating Lync
Acano solution: Single combined Acano server Deployment Guide R1.6 76-1054-01-H
Page 38
In this example:
 A Lync user can dial <name>@vc.example.com to set up a call with a SIP video endpoint
who is <name>@vc.example.com.
 A SIP video endpoint can dial <name>@example.com to set up a call with a Lync endpoint
who is <name>@example.com.
Adapt the example as appropriate.
6.4.1 Lync Front End Server configuration
To allow Lync clients to dial SIP video endpoints:
1. Add a Lync static route pointing to the Acano solution for vc.example.com.
6.4.2 VCS configuration
To route SIP video endpoint calls to Lync clients:
1. Add a search rule on the VCS to route calls with the suffix @example.com to the Acano
solution.
6.4.3 Acano solution configuration
Perform the following steps so that all calls to the Acano solution that are not matched to Acano
users or coSpaces are forwarded.
1. Sign in to the Web Admin Interface and go to Configuration > Incoming Calls.
2. In the Call Forwarding section, add a new rule as follows:
 Domain Matching Pattern = *
Wildcards are permitted in any part of a domain matching pattern.
(Unmatched calls with a domain that matches this pattern are forwarded using this rule.)
 Priority: To ensure that this rule is always used, its priority should be the highest of any
rules configured (any value, including 0, is acceptable if there are no other forwarding
rules configured).
(Rules are checked in order of priority; highest priority first. If two Domain Matching
Patterns would match a destination domain the rule with the higher priority is used.)
 Forward = forward
(If you select Reject calls that matched the Domain Matching Pattern are not forwarded
but terminate.)
 Rewrite Doman = no
The call will be forwarded using the domain that was called.
(If you select yes here, you must then complete the Forward Domain. The original
domain will be replaced with the one you enter in Forward Domain before the call is
forwarded.)
3. Click Add new.
SIP video endpoints can now call Lync clients by dialing <name>@example.com, and Lync
clients can call SIP video endpoints by dialing <endpoint>@vc.example.com.