Installation guide

Dial Plan Configuration – Integrating Lync
Acano solution: Single combined Acano server Deployment Guide R1.6 76-1054-01-H
Page 33
6 Dial Plan Configuration – Integrating Lync
6.1 Lync Clients Dialing into a Call on the Acano solution
This section provides the equivalent of the previous section but for Lync endpoints joining a
meeting hosted on the Acano solution. It uses the same call number/URI: adapt the example as
appropriate.
Figure 8: Example Lync clients calling into Acano server hosted meetings
6.1.1 Lync Front End Server configuration
To route calls originating from Lync clients to the Acano solution:
1. Add a Lync static route pointing to the Acano solution matching domain acano.example.com.
See the Appendix with an example for details.
6.1.2 Adding a dial plan rule on the Acano solution
1. Sign in to the Web Admin Interface and go to Configuration > Outbound Calls.
2. Set up a dial plan rule with:
 Domain = mycompany.com
 SIP Proxy = the IP address or FQDN of your Lync FE pool or server
 Local contact domain = callbridge.acano.mycompany.com