Installation guide

Dial Plan Configuration – SIP Endpoints
Acano solution: Single combined Acano server Deployment Guide R1.6 76-1054-01-H
Page 30
5.2.1 SIP call control configuration
This example assumes the SIP Call Control is a Cisco VCS but similar steps are required on
other Call Control devices. See the Third Party Deployment Guide for other examples such as
CUCM and Polycom DMA.
Set up a zone to route calls to the Acano solution by logging into the VCS as an administrator
and following the steps below.
1. Go to VCS Configuration > Zones > New.
2. Create the zone with the following:
 H.323 Mode = Off.
 SIP Mode = On
 SIP Port = 5060 (5061 if using TLS)
 SIP Transport = TCP or TLS, as appropriate
 SIP Accept Proxied Registrations = Allow
 Authentication Policy = Treat as authenticated
 SIP Authentication Trust Mode = Off
 Peer 1 Address = the IP address of the Call Bridge
5.2.2 VCS search rule configuration
Add a search rule on the VCS to route calls to the Acano solution by following the steps below
(e.g. to route any video endpoint call to a call on the Acano solution using the call prefix 88).
1. Go to VCS Configuration > Dial Plan > Search rules.
2. Give the rule a suitable name, e.g. VC EPs to Acano.
3. Set the following:
 Source = Any
 Request Must Be Authenticated = No
 Mode = Alias pattern match
 Pattern Type = Regex
 Pattern String = .*@acano.example.com
 Pattern Behavior = Leave
 On Successful Match = Stop
 Target = the zone you created for the Acano solution.
5.2.3 Creating a coSpace on the Acano solution
Create a coSpace on the Acano solution for endpoints to dial into as follows:
1. Sign in to the Web Admin Interface.
2. Go to Configuration > CoSpaces.
3. Add a coSpace with: