Installation guide

Dial Plan Configuration – SIP Endpoints
Acano solution: Single combined Acano server Deployment Guide R1.6 76-1054-01-H
Page 29
As shown in the figure above, the Lync FE server needs a Trusted SIP Trunk to the Acano
solution, configured to route calls originating from Lync clients through to Acano coSpaces,
Acano client users (native and WebRTC) and also SIP video endpoints. The subdomains
vc.example.com and acano.example.com should be routed through this trunk from the Lync FE
server to the Acano solution.
The SIP Call Control platform needs a SIP trunk set up to route calls to the example.com domain
(for Lync Clients) and acano.example.com (for coSpaces and Acano clients) to the Acano
solution.
The Acano solution requires a dial plan to route calls to example.com to the Lync FE server and
vc.example.com to the SIP Call Control platform.
The configuration required for the total solution is built up step-by-step below and therefore, to
plan your own installation, work through the steps in the order provided adapting the example as
appropriate.
5.2 SIP Endpoints Dialing a Call on the Acano Solution
As a starting point, consider using only SIP video endpoints and the configuration on the VCS
and Acano server to direct and host calls for these endpoints.
Figure 7: Example of SIP video endpoints calling into Acano server hosted calls