Installation guide

Dial Plan Configuration – SIP Endpoints
Acano solution: Single combined Acano server Deployment Guide R1.6 76-1054-01-H
Page 28
5 Dial Plan Configuration – SIP Endpoints
5.1 Introduction
In order for the Acano solution to be integrated in a SIP, Lync and voice environment,
connections need to be set up from the SIP Call Control, Voice Call Control and Lync FE server
to the Acano solution as shown in Figure 1 above. Changes to the call routing configuration on
these devices are required in order to route the calls that require the Acano solution for
interoperability correctly to it.
This example (see the figure below) assumes a company deployment which has a mix of SIP
video endpoints, Lync clients and IP phones: the Acano solution enables connectivity between
Lync clients and SIP video endpoints, and between Lync clients and IP phones.
The SIP video endpoints are configured on a domain called vc.example.com and the Lync
clients on example.com. You will need to adapt the example, as appropriate to your existing
Lync deployment.
Note: Although this figure and subsequent diagrams in this Deployment Guide use an Acano X
series deployment as the example, the instructions apply equally to virtualized deployments.
Figure 6: Example solution for dial plan configuration