Installation guide
Prerequisites and Deployment Overview
Acano solution: Single combined Acano server Deployment Guide R1.6 76-1054-01-H
Page 10
2.1.7 Host name
The hostname must be set for the Acano server:
1. If necessary, SSH into the MMP and log in.
2. Type:
hostname <name>
hostname london1
hostname mybox.example.com
3. Type:
reboot
Note: A reboot is required after issuing this command.
2.1.8 Other requirements
Read-only access to the LDAP server in order to import users and calling data automatically.
Refer to the section on LDAP configuration for more details.
Decision on a dial plan to use to reach calls hosted on the Call Bridge. The dial plan will
depend on your environment; that is whether you are making one or more of the following
types of call: Lync, SIP (including voice) or Acano client calls. Instructions for deploying this
dial plan are given in this document
Access to one or more of the following to test the solution: Lync clients, SIP endpoints
phones and/or Acano clients as appropriate
Access to a SIP Call Control platform if you intend to make SIP calls (for example, using
Cisco VCS) to make dial plan configuration changes. The changes required are given in this
document
Note: Information on setting up the SIP Trunk to a Cisco Unified Communications Manager
(CUCM), the Avaya CM and Polycom DMA has been removed from appendices in this
version of the Deployment guide. The information is now in a new Third Party Call Control
Guide available on acano.com/support.
Note: You can use other call control devices not listed in the Third Party Call Control Guide.
If you intend to integrate with an audio deployment, access to a Voice Call Control device
and this device must be attached to a PBX; it is not possible to connect an Acano server
directly to a PBX
If deploying in a Lync environment, access to the Lync Front End (FE) server to make dial
plan configuration changes there. The changes required are given in this document
2.1.9 Acano X series-specific prerequisites
A suitable environment: refer to the Hardware/Environmental Data Sheet for the required
power and cooling
Acano X series servers have two power modules, and, in some countries, country-specific
power cables are supplied for the AC power supplies. At installation you must connect both