User's Manual
Table Of Contents
- Table of Contents
- Preface
- Safety Instructions
- Rugged and Ready to Go
- Getting Started
- Wireless Connections
- Windows Basics
- Advanced Settings
- Configuring Pointer Device Settings
- Devices Screen
- Hardware Screen
- Settings Screen
- Advanced Screen
- General Screen
- Windows Screen
- Calibration Screen
- 1. Select the device you wish to calibrate from the Calibration Settings For: drop-down list.
- 2. Select the number of calibration points to be displayed during calibration under Calibration Points.
- 3. Set the calibration timeout length under Calibration Timeout.
- 4. Select the distance between the edge of the screen and calibration points under Start in at.
- 5. Select Transparent Background to calibrate on a transparent screen, or EEPROM calibration (Electrically Erasable Programmable Read-Only Memory) to use previously stored calibration settings.
- 6. Once you have configured all settings, you can save them under the standard Normal calibration mode, or as a new mode. To save the settings as a new calibration mode, tap Add, enter the name of the mode and tap OK to save.
- 7. Click Apply to save all changes.
- Status Screen
- About Screen
- Configuring Pointer Device Settings
- Specifications
XT1100 User Manual
Calibration Screen ................................................. 29
Status Screen ....................................................... 30
About Screen........................................................ 30
Specifications ...................................................... 31