Installation Guide

Green (G)
Black (Y or X)
White (W)
Red (X or Y)
FIGURE 1
1/2”
50 AMPERE LOCKING PLUGS AND CONNECTORS
QUESTIONS?
Email , call or text our
Customer Service Dept.
Direct: [phone]
Text: [phone]
[e-mail]
1. CABLE: Provide a cable of applicable ampacity, service and temperature rang
suitable for the condions of use and locaon. The plugs and connectors are
designed for use with 6 gauge cables with 4 conductors.
2. CABLE PREP: Remove out jacket 2” and strip each individual conductor 1/2” as
shown in Figure 1 Below. Make sure the wire is clean and a bright copper color.
Do not solder the ends of the wire. Feed the cable end through the housing.
4. ASSEMBLY: Select the proper plug or connector for your applicaon. Loosen the
screws from the face and remove the assembly from the outer body.
FOR DEVICES WITH A W TERMINAL:
Insert the green wire into the terminal with the green colored screw. (G)
Insert the white wire into the terminal with the silver colored screw. (W)
Insert the reamaining wires (white, red, black, etc.) into the terminals marked X,
Y or Z.
When making connecons, make certain they are secure, properly insulated
and there are no stray wire strands outside the terminals. Tighten the termi-
nal screws to 12-16 in-lbs torque. Assemble the housing over the device body;
the keyway in the housing and the body properly aligns the two parts. Tighten
the cord clamp assembly screws to a maximum 10-12 in-lbs torque. Lastly ght-
en the assembly screws.
www.ACWORKS.com
Green (G)
Black (Y or X)
White (W)
Red (X or Y)
FIGURE 1
1/2”
50 AMPERE LOCKING PLUGS AND CONNECTORS
QUESTIONS?
Email , call or text our
Customer Service Dept.
Direct: [phone]
Text: [phone]
[e-mail]
1. CABLE: Provide a cable of applicable ampacity, service and temperature rang
suitable for the condions of use and locaon. The plugs and connectors are
designed for use with 6 gauge cables with 4 conductors.
2. CABLE PREP: Remove out jacket 2” and strip each individual conductor 1/2” as
shown in Figure 1 Below. Make sure the wire is clean and a bright copper color.
Do not solder the ends of the wire. Feed the cable end through the housing.
4. ASSEMBLY: Select the proper plug or connector for your applicaon. Loosen the
screws from the face and remove the assembly from the outer body.
FOR DEVICES WITH A W TERMINAL:
Insert the green wire into the terminal with the green colored screw. (G)
Insert the white wire into the terminal with the silver colored screw. (W)
Insert the reamaining wires (white, red, black, etc.) into the terminals marked X,
Y or Z.
When making connecons, make certain they are secure, properly insulated
and there are no stray wire strands outside the terminals. Tighten the termi-
nal screws to 12-16 in-lbs torque. Assemble the housing over the device body;
the keyway in the housing and the body properly aligns the two parts. Tighten
the cord clamp assembly screws to a maximum 10-12 in-lbs torque. Lastly ght-
en the assembly screws.
www.ACWORKS.com