Service manual

88 Miscellaneous Mounting Accessories Welch Allyn Spot Vital Signs
IR dongle mounting accessory (REF 4200-170)
INSTALLATION INSTRUCTIONS:
Step 1 - Remove rubber base from
IR dongle
Step 2 - Place IR dongle into bracket
clamps
Step3-Tighten screws
Step 4 - Clean side of device housing
using alcohol wipe
Step 5 - Remove adhesive protective
paper from back of bracket
Step 6 - Place bracket flange (A)
on device surface (B) and
hole in bracket (C) over IR
window (D) as shown. Press
firmly to secure adhesive.
(Note: Max adhesive strength achieved in 24 hours.)
CAUTION: DO NOT Download any drivers
during the installation process for this
IR Rs232 device. Drivers are not required
and will interfere with communication
between the device and the
Electronic Medical Record.
Material #: 705633 Rev. B