Operating instructions

51
SV01L
Commissioning
Code Possible Settings
IMPORTANT
No. Name Default Selection
Segment #16
7
Segment #16
Frequency Setpoint
0.0 -500.0 {Hz} 500.0 If P112 = 1, negative sign forces reverse direction
7
Segment #16
Accel/Decel Time
20.0 0.0 {sec} 3600.0
7
Segment #16
Time in current step
0.0
0
0.0 {P708} 6553.5
0 {P708} 65535
Scaling/units depend on P708
Skip segment if time = 0
7
Segment #16
Digital Output State
0 Bit0 Relay bit = 0: OFF (De-energized)
bit = 1: ON (Energized)
The corresponding digital output/relay must
be set to accept value the from the sequencer:
P140, P142=27
Bit1 TB14
7
Segment #16 TB30
Analog Output Value
0.00 0.00 {VDC} 10.00 TB30 configuration parameter must be set to
accept this value: P150 = 10
End Segment
7
End Segment:
Frequency Setpoint
0.0 -500.0 {Hz} 500.0 If P112 = 1, negative sign forces reverse direction
P7
End Segment:
Accel/Decel Time
5.0 0.0 {sec} 3600.0
7
End Segment: Delay
before P793, 794 &
795 activation
0.0 {P708} 6553.5
0 {P708} 65535
Scaling/units depend on P708
7
End Segment:
Digital Output State
Bit0 Relay bit = 0: OFF (De-energized)
bit = 1: ON (Energized)
The corresponding digital output/relay must
be set to accept value the from the sequencer:
P140, P142=27
Bit1 TB14
7
End Segment: TB30
Analog Output Value
0.00 0.00 {VDC} 10.00 TB30 configuration parameter must be set to
accept this value: P150 = 10
7
End Segment:
Drive Action
0 0 Keep Running Recovery: Toggling the START SEQUENCE will
start the cycle from ‘end segment Stop’ or ‘end
segment DC Brake’.
1 Stop (based on P111)
2 Coast to Stop
3 Quick Stop
4 Coast with DC Brake
5 Ramp with DC Brake
WARNING!
If P795 = 0 then toggling the start sequence input will also restart the sequencer cycle but
in the interim where TB13X is open the drive will ramp to the standard or specified alternate
speed source depending on the drive configuration.
WARNING
If the input defined to “Start Sequence” is opened during a sequence, the drive will exit sequencer
mode and will run at the specified standard or alternate speed source (dependent on drive
configuration).