SDS

During a fire, irritating and highly toxic gases may be generated during combustion or decomposition. High temperatures can cause sealed
containers to rupture due to a build up of internal pressures. Cool with water.
DO NOT cut, drill, grind, or weld near full, partially full, or empty product containers.
Container could potentially burst or be punctured upon mechanical impact, releasing flammable vapors.
Fire-Fighting Procedures:
Isolate immediate hazard area and keep unauthorized personnel out. Stop spill/release if it can be done safely. Move undamaged
containers from immediate hazard area if it can be done safely. Water spray may be useful in minimizing or dispersing vapors and to
protect personnel. Water may be ineffective but can be used to cool containers exposed to heat or flame. Caution should be exercised
when using water or foam as frothing may occur, especially if sprayed into containers of hot, burning liquid.
Dispose of fire debris and contaminated extinguishing water in accordance with official regulations.
Special Protective Actions:
Wear protective pressure self-contained breathing apparatus (SCBA) and full turnout gear.
SECTION 6) ACCIDENTAL RELEASE MEASURES
Emergency Procedure:
ELIMINATE all ignition sources (no smoking, flares, sparks or flames in immediate area).
Do not touch or walk through spilled material.
Isolate hazard area and keep unnecessary people away. Remove all possible sources of ignition in the surrounding area. Notify authorities
if any exposure to the general public or the environment occurs or is likely to occur.
If spilled material is cleaned up using a regulated solvent, the resulting waste mixture may be regulated.
Recommended Equipment:
Positive pressure, full-facepiece self-contained breathing apparatus (SCBA), or positive pressure supplied air respirator with escape
SCBA (NIOSH approved).
Personal Precautions:
Avoid breathing vapor. Avoid contact with skin, eye or clothing. ELIMINATE all ignition sources (no smoking, flares, sparks or flames in
immediate area). Do not touch damaged containers or spilled materials unless wearing appropriate protective clothing.
Environmental Precautions:
Stop spill/release if it can be done safely. Prevent spilled material from entering sewers, storm drains, other unauthorized drainage systems
and natural waterways by using sand, earth, or other appropriate barriers.
Methods and Materials for Containment and Cleaning Up:
Cover spills with inert absorbent and place in closed chemical waste containers.
SECTION 7) HANDLING AND STORAGE
General:
Wash hands after use.
Do not get in eyes, on skin or on clothing.
Do not breathe vapors or mists.
Use good personal hygiene practices.
Eating, drinking and smoking in work areas is prohibited.
Remove contaminated clothing and protective equipment before entering eating areas.
Eyewash stations and showers should be available in areas where this material is used and stored.
Ventilation Requirements:
Use only with adequate ventilation to control air contaminants to their exposure limits. The use of local ventilation is recommended to
control emissions near the source.
Storage Room Requirements:
Keep container(s) tightly closed and properly labeled. Store in cool, dry, well-ventilated areas away from heat, direct sunlight, strong
oxidizers and any incompatibilities. Store in approved containers and protect against physical damage. Keep containers securely sealed
when not in use. Indoor storage should meet OSHA standards and appropriate fire codes. Containers that have been opened must be
carefully resealed to prevent leakage. Empty containers retain residue and may be dangerous.
Use non-sparking ventilation systems, approved explosion-proof equipment and intrinsically safe electrical systems in areas where this
product is used and stored.
Do not cut, drill, grind, weld or perform similar operations on or near containers. Do not pressurize containers to empty them.
Store at temperatures below 120°F.
SECTION 8) EXPOSURE CONTROLS/PERSONAL PROTECTION
Eye Protection:
NAT01004, NAT01005
Page 3 of 6