Instructions / Assembly

29
PROGRAMMING
DISPLAY BRIGHTNESS
To adjust the brightness of the display, set the controller to OFF Mode, then press the up or down
button to increase or decrease the brightness level. The brightness range is 1/2/3/A3.
FAHRENHEIT OR CELSIUS
To switch between Fahrenheit and Celsius readings, set the controller to OFF Mode. Hold the up
button to switch to Fahrenheit (°F) and the down button to switch to Celsius (°C).
ECO-MODE
To turn off the LCD display, press the LEAF button. While the screen is off, all programs, settings,
and alarms will run in the background. You can activate ECO Mode while the controller is locked. To
exit ECO mode, press any button.
TEMPERATURE CALIBRATION
To adjust the temperature that the probe sensor is measuring, press the MODE and UP button
simultaneously. This can be done while the controller is any mode. The calibration cycle ranges
from -8°F to 8°F (or -4°C to 4°C). You may use this setting to match the controller's temperature
reading with your thermostat's reading.
HUMIDITY CALIBRATION
To adjust the probe sensor’s humidity reading, press the MODE and DOWN button simultaneously.
This can be done in any mode. The calibration cycle ranges from -8% to 8%.
CONTROLLER LOCK
To lock the controller and prevent accidental setting changes, hold the LEAF button for three or
more seconds. While the display is locked, you will not be able to switch modes or adjust settings.
You will only be able to put the controller in ECO display. Holding the LEAF button for three or more
seconds will unlock the controller.