User manual

– 53 –
The mounting site must be
• firm
• dry
• free of dust, grease or loose paint,
etc.
Application:
a) Remove the information sticker
and the protective film from the
self-adhesive surface (Fig. 3) of the
magnetic holder.
b) Press the adhesive surface of the
magnetic holder for approx. 10
seconds firmly onto the mounting
surface.
c) Fit the alarm unit onto the
magnetic holder.
d) The adhesive bond will reach its
final strength after approx. 72 hours.
H,IUHTXLUHGWKHXQLWFDQEHUHPR
ved from the magnetic holder by
pulling it gently vertically away
1.2 Adhesive mounting using optional
נ[LQJPDWHULDOWKLQGRXEOHVLGHG
DGKHVLYHנOPDVSHUYIGE*HUPDQ
Fire Protection Association) 14/01
4DQG(1ъэящэыщщю$&ыщщёLQ
addition to 1.1
The additional use of this optional
adhesive produces an
ʥ H[WUHPHO\נUP
• and long-lasting joint between the
 DODUPXQLWDQGWKHנ[WXUHDQGWKXV
with the installation site.
• The alarm unit cannot now be
removed by pulling it from the
 PDJQHWLFKROGHUWKLVPHDQVVLJQLנ
cantly greater security against
 XQDXWKRULVHGUHPRYDOWKHפHWF
Only use this method of Ϧxing when
you are absolutely certain that the
unit must remain permanently Ϧxed
and that it should not be removed.
Fig. 3
GB