User manual

– 44 –
For this see section: Setting up other
RISAs; Connection Mode and Creating
a Radio Group
If LED then lights red:
• Alarm is outside radio range of other
devices
• Indirect connection via repeating or
routing also not possible
• Time allowed for connection mode
has expired
If this occurs please check:
• Are other alarms still in connection
 PRGH/('ףDVKLQJ\HOORZDWUHJXODU
intervals)?
• If not: see section “Extending the
Radio Group, Entering Connection
mode and Repeat Connection
Attempts”.
Completing Setup of Radio Group
Setup of the radio group is automatically
HQGHGъщPLQXWHVDפHUDFWLYDWLRQRIWKH
ODVWSODQQHGDODUP$פHUWKLVQRQHRI
the units’ LEDs give any signal. Connec-
tion mode can also be ended immedi-
DWHO\E\EULHף\SUHVVLQJWKHUDGLREXWWRQ
with the black activation pin on any
alarm within the group. This causes the
LEDs of all devices to go out.
Radio Group Function Test
Press and hold the Test/Stop button for
2-3 seconds to invoke a self-test on this
device:
Beep 1x
Holding the Test/Stop button down
longer, until the second beep, issues
a radio signal that initiates a self-test
for all alarms within the radio group.
This test should be performed regularly,
every 3-6 months, to check the radio
group.
Beep 1x
Press for 2 – 3 seconds
Press for 2 – 3 seconds
until second beep
Netword setup