operation manual

– 28 –
e) The adhesive bond will reach its
  
  
2. Drilled hole mounting
Application:
a) Using an 8-mm drill bit, drill a
hole at the installation position
(take care not to strike any electric
  
b) Insert the 8-mm dowel into the
  
c) Push the supplied 5-mm counter-
sunk screw through the bottom of
the magnetic holder and into the
  
d) Tighten the screw into the dowel
so that the screw sits flush and is
fully sunk into the recess provided
  
e) Only tighten the screw enough to
prevent the magnetic holder from
  
f) Place the device on the magnetic
  
 
ved from the magnetic holder by
pulling it gently in a vertical
  
GENERAL SAFETY GUIDELINES
Smoke alarms are designed to help

they cannot extinguish a fire nor pre-
vent it starting, nor can they notify

ted by the presence of combustion
gases, smoke alarms emit a loud alarm

Despite great care in the manufacture
of smoke alarms, it is also possible
that a fault may occur that prevents
the device from warning of a potential
fire, or from doing so in good time!
The usual precautions in relation to
fire, flammable materials and techni-

ved! Please do not expose the device
to direct sunlight or extreme heat,
because it could damage the built-in

