User manual

Preface

Dear Customer,

Thank you for purchasing this photo-electric smoke detector. You made

the right decision in choosing this state-of-the-art technology, which

complies with the current standards of domestic and European regulations.

The CE has been proven and all related certifications are available from

the manufacturer upon request. To maintain this status and to guarantee

safe operation, it is your obligation to observe these operating instructions.

Notes

The smoke detector is used together with a burglar alarm system or fire

hazard warning system. It is used in locations with low dust pollution

(residential buildings, offices) or where thick smoke can be expected in the

event of a fire (such as smouldering furniture).

The smoke detector reacts to smoke that reaches its smoke chamber.

Caution:

Smoke detectors cannot be used to prevent fire. They are used merely to

react to specific fire characteristics. During installation, make sure that the

detector is placed in accordance with local fire precaution regulations and

recommendations.

This detector is designed for indoor use only.

To ensure perfect functioning of your smoke detector, please note the

following:

• Do not disassemble the detector.

• Avoid anything that may prevent the flow of air to the detector.

Following installation, check that all detectors in your fire alarm system are

working and repeat this check at least once a year.

Positioning

For your own and your customers’ safety, place the smoke detector

centrally above the area to be supervised. Make sure that the detector is at

least 30 cm away from any walls.

Use smoke detectors only in rooms with low dust pollution or where no

fires with highly flammable materials are expected.

Installation

1. Separate the detector from the base plate by pressing detector and

base plate together and unscrewing in an anticlockwise direction.

2. Installing the base plate

2.1. Using the screws and wall-plugs supplied, screw the base plate

to the wall or ceiling.

2.2. The detector needs four connections cables for installation.

Fig. 1 shows the wiring diagram, Fig. 2 the base plate.

The connection mark numbers are also shown inside the base

plate.