Owner`s manual

Power/Standby Buttons

The iScan VP50 remote has a Power and a Standby button. The Power button always turns the iScan

VP50 on and the Standby button always put the unit into Standby mode.

Curtain Button

The iScan VP50 remote has a Curtain button which allows you to close a ‘curtain’ over the image.

This feature is especially useful when an image is paused on a display susceptible to burn-in, like a

plasma or CRT-based display.

Remote Control Battery Installation

The remote control uses two AAA batteries, which should be replaced as needed. Two AAA batteries

are included.

To install the remote control batteries:

1. Locate the battery compartment on the back of the remote control.

2. Remove the cover from the back. To do this, press the tab attached to the cover

and pull the cover with the guide on the back of the remote control.

3. Remove the old batteries (if applicable).

4. Insert two new AAA batteries in the compartment as shown on the inside of the battery

compartment. Make sure the batteries are correctly inserted, observing the proper polarity.

5. After installation, replace the cover and dispose of the old batteries (if applicable).

Menu Navigation

You can control the iScan VP50 as follows:

• From the front panel controls

• From the iScan VP50 remote control

• From a programmed universal remote control

• Using the serial connection on the back panel

The menu navigation controls on the remote control are duplicated on the front panel of the iScan VP50.

To navigate the menu:

1. Press the

Menu button.

2. Use the directional buttons (t ,p,q,u) to highlight the parameter you want to change.

3. Press the Enter or u button to select the parameter and the p and q buttons to change

the chosen parameter. Press the t button to stop adjusting a parameter and to return

to navigating the OSD.

4. Press the Exit button to exit out of the menu/OSD

Unpacking and Inspection

Please verify that your iScan VP50 carton contains the following items:

• iScan VP50 Video Processor

• Universal 6V@7A AC-to-DC Power Converter

• US IEC Power Cord (International Customers, consult your local authorized DVDO reseller)

• Remote Control

• iScan VP50 Owner’s Manual

• iScan VP50 Quick Start Guide