Owner`s manual

3
Picture Control
_
Contrast
_
5
In this example, the instructions are to adjust the ‘Contrast’ to a value of ‘5’. To do this, press Picture
Control and then press q once, highlighting ‘Contrast’ in the On Screen Display (OSD) or if you are
looking at the front panel display (FPD) you will see ‘Picture Control’ on the top line and ‘Contrast’ on
the bottom line. This is abbreviated as ‘Picture Control / Contrast’. Next press u to adjust the setting
and then press p until the value is ‘5’. Finally, press Exit.
The t , u,q, and p symbols refer to the navigational keys on the remote control and the front panel
of the iScan.
Remote Control Overview
For additional information about the functions of these buttons, turn to the pages given in parentheses
( ).
An asterisk (*) indicates this feature will be implemented in future software.
INPUT S ELECT
STANDBY
POWER
INPUT
ADJUST
CONFIG
PICTURE
CONTROL
OUTPUT
SETUP
MENU EXIT
16:94:3
AUTO
VIDEO 1S-VIDEO 1COMP 1HDMI 2
VIDEO 2S-VIDEO 2COMP 2HDMI 3
ENTER
HDMI 4
BORDER CROP
INFO
CURTAIN
MEMORIES
RGBHV
HDMI 1 SDI
ASPECT
ZOOM PAN
ON/OFF
DISPLAY
PROFILES
VIEWING
MODES
INPUT
ASPECT
RATIO
TEST PATTERN
ENTER
Standby
Info
Curtain
Output Setup
Configuration
Picture Control
Input Adjust
Menu
Border
Zoom
Input Select
(HDMI 1, HDMI 2, HDMI 3, HDMI 4,
Component 1, Component 2,
RGBHV/Component,
S-Video 1, S-Video 2,
Video 1, Video 2, AUTO)
Aspect
Exit
Crop
Pan
Power
Input Aspect
Ratio
Viewing Modes
Display Profiles
4:3
16:9
Test Patterns
(Left, On/Off, Right)
4
23
29
*
*
18
4
17
16
16
4
9
4
25
23
21
19
4
4
17
15
17
15