Owner`s manual
23
Auto Standby
The default setting is ‘Off’, which means iScan VP50 is always in Active mode, regardless of the
activity state of the selected input. If Auto Standby is ‘On’, the iScan VP50 goes into Standby mode
30 seconds after the selected input becomes inactive. To see the current setting, press p or q. Then
press the same button again to change the setting.
LED Brightness
This selection allows the user to congure the behavior of the Front Panel LED brightness. The
‘Normal’ parameter adjusts the brightness of the Front Panel LED when the menu is being navigated.
The ‘Navigate’ parameter adjusts the brightness of the Front Panel LED during normal usage, when
the menu is not being navigated.
User Mode
You have limited access to the output timing controls in ‘Normal’ mode, which is the default.
In ‘Advanced’ user mode, you have access to the complete set of output timing controls. Push the
q button to see the current setting and the FPD displays either ‘Normal’ or ‘Advanced’ user level.
Push the q button again to select the alternate mode.
Serial Port Rate
The serial port is used by the automation system controllers to control the iScan VP50. The serial port
baud rate defaults to 19200 bps, but can be changed using the p or q button.
The supported baud rates are:
• 4800 bps (4.8K)
• 9600 bps (9.6K)
• 14400 bps (14.4K)
• 19200 bps (19.2K)
• 38400 bps (38.4K)
• 57600 bps (57.6K)
Factory Default
The Factory Default option allows you to reset system settings to the factory default.
1- Press either the p or q button. The FPD displays ‘No’.
2- Press the same button to switch to ‘Yes’.
3- Conrm this selection by pressing the Enter button.
The default factory settings are as follows:
• Input Selection: Auto
• Input Aspect Ratio: 4:3 for 480i/p and 576i/p inputs, 16:9 for 720p and 1080i inputs
• Picture Controls: midrange (0)
• Chroma Filter (CUE-C): Auto
• Output Aspect Ratio: (16:9)
• Output Resolution: 480P
• Output Color Space: RGB 4:4:4
• Auto Standby: Off
• Frame Rate
• 60Hz input - 1:1 source-locked output
• 50Hz input - unlocked at 59.94 Hz
• User Mode: Normal
• Video Input Priority Settings:
• 1 – Component 1