Owner`s manual
15
S E C T I O N 4 – M E N U O P T I O N S
Input Select
There are eleven video inputs on the iScan VP50:
• VIDEO 1 - Video 1 (Composite)
• VIDEO 2 - Video 2 (Composite)
• S -VIDEO 1 - S -Video 1
• S -VIDEO 2 - S -Video 2
• COMPONENT 1 - Component/RGBs 1
• COMPONENT 2 - Component/RGBs 2
• HDMI 1 - HDMI 1
• HDMI 2 - HDMI 2
• HDMI 3 - HDMI 3
• HDMI 4 – HDMI 4
• SDI – SDI
• AUTO - Automatic active input detection and selection
These inputs can be accessed in ve different ways:
• Using the front panel using the p and q buttons
• Using the remote control with the direct access buttons
• Using a universal remote programmed with the discrete codes
• Using the OSD from the front panel or from the remote to access the Input Select menu
• Using RS232 Serial Automation Protocol described in the appendix.
Input Aspect Ratio Control
The Input Aspect Ratio control selects the aspect ratio for the current input signal. The iScan VP50
automatically converts from the selected input aspect ratio to the selected output aspect ratio.
The iScan VP50 allows the user to dene two parameters for each input signal, the ‘Frame’ and the
‘Active AR’
For the Zoom, Pan and Borders functions, push the p or q button to select the two control settings
available: horizontal and vertical. Push the Enter button to adjust each setting.
• Push p and q to increase or decrease the setting.
• Push Exit again to exit this mode.
NOTE: The Zoom and Pan functions are applied to the input signal, not the output. This is an important
consideration, especially for the Pan function. For example: If you do not zoom a full frame image more
than 100%, there is nothing to pan. However, if part of the image is not on the screen, then the Pan
function will work.
The VP50’s menu is exit automatically after 30 seconds of no user interaction.
Video input signals are usually classied in the following two ways:
• Frame Aspect Ratio
• Active Input Aspect Ratio