Owner`s manual

S E C T I O N 3 – S E T U P

Initial Set-Up

Once you have installed the iScan VP50 into your system, you must properly congure it for the display

device being driven. The iScan VP50 is shipped from the factory with the following preset default settings:

• Input Select is set to AUTO, to automatically detect an active input in a pre-congured priority.

• The Digital Video output is selected with RGB 4:4:4 color space

• The output format is set to ATSC (DTV) 480p

Use either the remote control or the front panel controls to perform the initial setup of the iScan’s

output. The procedure below uses the front panel buttons to perform initial setup. Accessing the iScan

VP50’s OSD is crucial, not only in allowing you to navigate the menu of the iScan VP50, but also to

let you know that the iScan is sending a compatible signal to the display. If the OSD is not visible on

the display’s screen when you press one of the sub-menu buttons on the remote control, then you

must congure the iScan with the Output Setup menu to output a signal that the display can accept.

UsethesestepstoallowyoutoseetheOSD.

STEP 1 - Power Up

1. Attach the removable power cord to the external power supply.

2. Plug the removable power cord into a wall outlet or power conditioner, if applicable.

3. Plug the small connector attached to the cable that comes out of the power supply

into the iScan VP50. The iScan VP50 should power on and display ‘DVDO iScan VP50 /

STEP 2 - Connect the iScan VP50 to your system

Displays with a DVI or HDMI Input

The default output on the iScan VP50 is digital RGB 4:4:4 (DVI Standard). If you have changed this

setting, follow these instructions to change the settings back.

1. Press the Menu button on the front panel of the iScan VP50 once. You should see

‘Main Menu / Input Select’ on the FPD.

2. Press the p button twice. You should see ‘Main Menu / Conguration’ on the FPD.

3. Press the u button. You should see ‘Conguration / Test Pattern’ on the FPD.

4. Press the q button until you see ‘Conguration / Factory Default’ on the FPD.

5. Press the u button and you should see ‘Factory Default / No’. Press the q button once

so that ‘Factory Default / Yes’ is displayed on the FPD. Press the Enter button and the

unit will reset to factory default settings and you should see the iScan VP50’s On

Screen Display (OSD) on your screen.

Displays with a VGA HD-15 or 5BNC RGBHV input

1. Press Menu on the front panel of the iScan VP50 once. You should see ‘Main Menu /

Input Select’ on the FPD.

2. Press p once. You should see ‘Main Menu / Output Setup’ on the FPD.

3. Press Enter. You should see ‘Output Setup / Analog/Digital’ on the FPD.

4. Press Enter. You should see ‘Analog/Digital / BNC (Analog)’. If this setting is already set

to ‘BNC (Analog)’, press the ? one time. If this setting is set to ‘HDMI (Digital)’, press p

once and then press Enter. You should see ‘Output Setup / Analog/Digital’ on the FPD.

5. Press q four times. You should see ‘Output Setup / Color Space’ on the FPD.