Owner`s manual

9
The iScan VP50 accepts digital audio sourced from DVD players, satellite receivers, digital set top
boxes, HD-DVD players, BluRay players, game consoles, and other digital audio devices. These inputs
are compatible with most consumer digital audio formats, including CD-Audio (44.1kHz/16 bit LPCM),
Dolby Digital, and DTS. The coaxial digital audio inputs are compatible with any format with a sam-
pling frequency between 24kHz and 192kHz, and with a data word structure up to 24 bits in length.
The optical digital audio inputs are compatible with any format with a sampling frequency between
24kHz and 96kHz and with a data word structure up to 24 bits in length. The HDMI audio inputs are
compatible with HDMI 1.1 audio formats.
Audio Outputs
There are two discrete digital audio outputs, one coaxial and one optical. Both are active at the same
time, with the selected input audio stream. The HDMI output carries both audio and video.
Info Screen
Press the Info button to display a window that shows information about the system including:
• Input Status
— Video Source
— Signal Type
— Audio Source
— Aspect Ratio (Frame AR/Active AR)
• Output Status
— Resolution
— Frame Rate
— Line Rate
— Aspect Ratio (Display AR/Screen AR)
This screen can be helpful during troubleshooting.
Power Supply Input
The iScan VP50 comes with a 6V@7A AC-to-DC converter power supply, which accepts 100-240 VAC
at 50/60Hz.
To attach power to the unit:
1. Attach the removable power cord to the external power supply.
2. Plug the removable power cord into a wall outlet or power conditioner, if applicable.
3. Plug the small connector attached to the cable that comes out of the power supply into
the ‘DC In’ port on the back of the iScan VP50. The iScan VP50 should power on and
display ‘DVDO iScan VP50 / Powered by ABT’ on the FPD for a couple of seconds.
IMPORTANT: Use only the power supply that came with your iScan VP50, or a replacement
procured directly from ABT.