Owner`s manual

7
S E C T I O N 2 – B A S I C O P E R A T I O N
Front Panel Overview
Status LED – This displays the current state of the iScan VP50
Off = The unit is in standby mode
Red = No signal detected
Blue = The unit is processing the signal
Blinking Blue = There is a problem with HDCP authentication
Green = The unit detects an unsupported signal
On/Standby – This toggles unit power between On and Standby.
IR Window – This is where all IR commands are received by the iScan. Do not obstruct
this window.
Front Panel Display (FPD) – This is where all information from the on screen display (OSD) is du-
plicated to assist in the setup of your iScan.
NOTE: When navigating the OSD, the FPD always shows the current selection on the bottom line
and the menu/submenu item on the top line. When you change a value of a setting, the value is on
the bottom line and the title of the parameter is on the top line.
Navigation Keys – These keys are duplicated on the remote control and function exactly the
same.
NOTE: Switching Inputs using the Navigation keys – You can switch inputs on the front panel of
the iScan VP50 or using the remote using the navigation keys. To do this, press the p or q without
pressing the Menu button rst.
Rear Panel Overview
t ,p,q,u
MENU
EXIT
Front Panel Display (FPD)
Adjustment Buttons
Up
On/Standby Left Down Right
Menu
Exit
IR Window
Status LED
H D M I
1 2 3 4
INPUT
OUTPU T
1
3
2
4
SERIAL PORT
ANA LOG AUDIO IN PUT
Y (G) Pb (B) Pr (R) H V
Y (G) Pb (B) Pr (R)
1
2
1
2
1
2
1
2
C O M P O N E N T
L R
A N A L O G V I D E O
OUTPUT
I
I
N
P
U
T
O
U
T
P
U
T
Component 1
(YPbPr or RGB)
Component 2
(YPbPr or RGB)
Power
Composite
Video 1
Composite
Video 2
Digital
Audio Out
(optical)
Digital
Audio Out
(coaxial)
Digital Audio
Inputs 1, 2
(optical)
Digital Audio
Inputs 3, 4
(coaxial)
Serial Port
S-Video 1
S-Video 2Sync 2
Sync 1
Analog Video
Output
HDMI Inputs
1, 2, 3, 4
HDMI Output
Analog Audio
Inputs L, R
D I G I T A L A U D I OS-VIDEO VID EOSYNCPOWER
SDI Input
Analog Video
Input
INPUT
DC In
P
U
T
S