Owner`s manual

6
The following types of displays with digital video inputs should be compatible with the iScan
VP50 since a large majority of them can support higher resolution signals:
• Plasma displays
• LCD-based at panel and front & rear projection displays
• DLP-based front & rear projection displays
• LCoS-based front & rear projection displays (D-ILA™ & SXRD™ included)
• CRT-based Direct View and front and rear projection displays
Installation Guidelines
Take special care with the iScan VP50 installation to ensure optimal performance. Pay particular attention
to the bulleted items that begin below and to other precautions that appear throughout this guide.
Do...
• Install the iScan VP50 on a solid, at, level surface such as a table or shelf. You can
also install the iScan VP50 in a standard 19” equipment rack using an optional rack-mount
kit available from authorized DVDO resellers or directly from DVDO.
• Select a dry, well-ventilated location.
• Use only the included external power supply.
• Avoid excessive humidity, sudden temperature changes or temperature extremes.
• Use only accessories recommended by the manufacturer to avoid re, shock or
other hazards.
• Unplug your iScan VP before cleaning. Use a damp cloth for cleaning.
Don’t...
• Install the iScan VP50 on an unstable surface or one that is unable to support all four of its
feet, unless it is installed in an equipment rack.
• Stack the iScan VP50 directly above heat-producing equipment such as power ampliers or
other components that generate heat during use.
• Expose the iScan VP50 to a high temperatures, humidity, steam, smoke, dampness, or
excessive dust. Avoid installing the iScan VP50 near radiators and other heat producing
appliances.
• Install the iScan VP50 near unshielded TV or FM antennas, cable TV decoders, and other
RF-emitting devices that might cause interference.
• Place the iScan VP50 on a thick rug or carpet or cover the iScan VP50 with cloth. This might
prevent proper cooling.
• Attempt to service this unit. Instead, disconnect it and contact your Authorized DVDO
Reseller or contact Anchor Bay Technologies directly.
• Open or remove unit panels or make any adjustments not described in this manual.
Attempting to do so could expose you to dangerous electrical shock or other hazards.
It may also cause damage to your iScan VP50.
• Obstruct the front panel IR receiver window shown in “Remote Control Overview”.
• Do not attempt to use the remote control out of line of sight with the IR receiver. Doing so
will cause improper operation.