Owner`s manual
28
LCD
Rear Projection – 1280x720 (720p), 1366x768
Front Projection – 1024x768, 1280x720 (720p), 1366x768
Direct View – 1024x768, 1280x720 (720p), 1366x768, 1920x1080 (1080p)
LCoS
Rear Projection – 1280x720 (720p), 1366x768, 1920x1080 (1080p)
Front Projection – 1024x768, 1280x720 (720p), 1366x768, 1920x1080 (1080p)
CRT
Rear Projection – 480p, 540p, 1080i
Front Projection – 1280x720 (720p), 1280x960, 1440x960, 1440x1152, 1920x1080 (1080p)
NOTE: Driving a CRT display beyond its capabilities may damage your display. Please check with
DVDO if you are unsure what your displays capabilities are.
Initial Setup of the iScan to Your Display:
Test Patterns used: Frame Geometry
Checker board
Vertical Lines
Horizontal Lines
Judder
The following information uses a Fujitsu 50” plasma (Model P50XHA10US) as an example. As
stated above, this display can only be addressed at 1:1 pixel mapping with an output resolution
of 1360x768 from an external video processor.
1 - Select the preset which is closest to the output resolution that you need. In this situation,
the closest preset is 1366x768.
Output Setup
_
Format
_
1366x768
2 - Display the ‘Frame/Geometry’ test pattern to verify that the image is positioned correctly
on your display.
Conguration
_
Test Patterns
_
Frame Geometry
NOTE: To turn the test patterns on and off, use the Test Patterns button on your remote control.
You can also navigate backwards and forwards through the test patterns, using the < and > buttons
respectively.
Frame/Geometry Test Pattern Displayed Correctly (Image B)