Owner`s manual
10
S E C T I O N 3 – S E T U P
Initial Set-Up
Once you have installed the iScan VP20 into your system, you must properly congure it for the display
device being driven. The iScan VP20 is shipped from the factory with the following preset default settings:
• Input Select is set to AUTO, to automatically detect an active input in a pre-congured priority.
• The Digital Video output is selected with RGB 4:4:4 color space
• The output format is set to ATSC (DTV) 480p
Use either the remote control or the front panel controls to perform the initial setup of the iScan’s
output. The procedure below uses the front panel buttons to perform initial setup.
Accessing the iScan VP20’s OSD is crucial, not only in allowing you to navigate the menu of the iScan
VP20, but also to let you know that the iScan is sending a compatible signal to the display. If the OSD is not
visible on the display’s screen when you press one of the sub-menu buttons on the remote control, then
you must congure the iScan with the Output Setup menu to output a signal that the display can accept.
Use these steps to allow you to see the OSD.
STEP 1 - Power Up
1. Attach the removable power cord to the external power supply.
2. Plug the removable power cord into a wall outlet or power conditioner, if applicable.
3. Plug the small connector attached to the cable that comes out of the power supply
into the iScan VP20. The iScan VP20 should power on and display ‘DVDO iScan VP20 /
Powered by ABT’ on the FPD.
STEP 2 - Connect the iScan VP20 to your system
Displays with a DVI or HDMI Input
The default output on the iScan VP20 is digital RGB 4:4:4 (DVI Standard). If you have changed this
setting, follow these instructions to change the settings back.
1. Press the Menu button on the front panel of the iScan VP20 once. You should see
‘Main Menu / Input Select’ on the FPD.
2. Press the Up button twice. You should see ‘Main Menu / Conguration’ on the FPD.
3. Press the Right button. You should see ‘Conguration / Test Pattern’ on the FPD.
4. Press the Down button until you see ‘Conguration / Factory Default’ on the FPD.
5. Press the Right button and you should see ‘Factory Default / No’. Press the Down button
once so that ‘Factory Default / Yes’ is displayed on the FPD. Press the Enter button and
the unit will reset to factory default settings and you should see the iScan VP20’s
On Screen Display (OSD) on your screen.
STEP 3 - Connecting Your Sources to the iScan VP20
Up to 9 video sources can be connected to the iScan VP20. Use the following suggestions for
connections to several popular video sources.