User Guide

Error Messages
Page 66
C. Error Messages
This section lists the error messages that the controller might produce and tells you
what to do. There are two types of message - information and fault. The information
messages are normally just to help you out. The fault messages indicate that there is a
problem with the controller and you will need to take some action.
Information messages
Message Explanation Solution
You need to select
some heads first
You can’t use the colour or
gobo option unless you’ve
selected some heads
Use Head Select to select one
or more heads
Scene has not been
programmed
You tried to recall a scene
that isn’t programmed
Choose a scene with a light
above the button
Chase has not been
programmed
You tried to recall a chase
that isn’t programmed
Choose a chase with a light
above the button
Deselect other heads
to use switch pack
The head you are trying to
select is a switch pack, you
need to deselect all other
heads to use it
Press Cancel to deselect
other heads, then select the
switch pack
Use [Colour] to
control switch pack
You are trying to use the
Gobo option with a switch
pack
Use the Colour set option to
control the switch pack
Playback Only Mode
This option locked
The unit is ‘locked’ and this
option cannot be used
Unlock the unit (if you know
the code it was locked with)
by holding down the Save
button
Invalid head setup
found, defaults set
Invalid settings found in head
setup, replaced by default
settings
Check the setup of all heads
and correct any errors (may
be caused by corruption or
entry error).