User Guide

Save
Page 46
11.Save
The Save button has three main functions; it allows you to save scenes, save chases
and alter the system setup options.
Note: Save Scene and Save Chase functions are not accessible when the
controller is locked in playback only mode.
11.1 Saving Scenes
Press Save, then Scene to save a scene. Section 7.1 on page 26 gives you all the
information on saving scenes.
11.2 Saving Chases
Press Save, then Chase to record a chase. Section 9.1 on page 34 gives you
instructions on saving chases. Any chases which are running will be turned off when
you select this option.
11.3 System setup
You enter system setup mode by holding down Save for longer than 2 seconds.
Note: If the controller is locked in playback only mode, you will have to enter
the access code before you can use this option.
There are 8 possible actions which are displayed one after the other. You can:
1. lock the controller into Playback Only mode
2. define what will happen when the Control socket is activated
3. define how the controller will start up when first turned on
4. set options for how the Light Show mode works
5. set options telling the controller how to interpret MIDI information
6. display information about the controller
7. Reset all options to factory defaults (does not affect scenes or chases)
8. Set the output to ‘highest takes precedence’ rather than ‘add’
9. Gobo-only blackout mode
Press the number key of the option you want to select (you don’t have to wait for it
to be displayed).