User Guide

Chase
Page 40
9.3 Chase Setup mode
This function allows you to erase chases, and to set up the chase run and chase auto-
select modes. You get into chase setup mode by holding down the Chase button for
2 seconds.
Note: You won’t be able to select this option if the controller is in ‘Playback
Only’ mode.
Chase Setup
1-Erase chase
There are 6 possible actions which are displayed one after the other. You can:
1. erase an individual chase
2. erase a bank of chases
3. copy an individual chase
4. copy a bank of chases
5. set up the chase run mode (auto or manual)
6. set up the chase auto-select mode
7. set up the chase link mode
8. clear the links between chases
9. set an option which automatically runs a chase when you finish saving it
Press the number key of the option you want to select (you don’t have to wait for it
to be displayed).
1: Erase chase
This option allows you to erase an individual chase. You select the chase to erase
exactly as if you were recalling it. You can change bank by pressing the Bank button.
The controller will check you really want to erase it before wiping the memory for
that chase. (You don’t need to erase the chase if all you want to do is change it - you
can just overwrite the old chase).
2: Erase whole bank
This option erases a complete bank of 16 chases. You select the bank of chases to
erase (1 to 4) exactly as if you were selecting a bank of chases to recall. The controller
will check you really want to erase the bank before wiping the memory for every
chase in the bank.
3: Copy individual chase
This option allows you to copy a chase from one position to another. If you want to
edit one of the pre-programmed chases, you can use this function to copy the chase
to a user-programmed chase, where you can edit it.