User Guide

Chase
Page 35
Storing a new chase
The unit will display
Step 01:Select scene
Scene bank 01
The unit is now in Scene Recall mode, and you can use the normal Scene recall
procedure. Press Bank to change the scene bank. When you choose a scene, the
controller will output the scene and store it as a step in the chase.
For a short period, the unit will display
Step 01 stored
Press [Chase] to end
and then go back to the scene select display.
You can continue to enter steps by selecting scenes; the display shows you the current
step number. If you change your mind about the scene you’ve just stored, you can
press Cancel to go back a step. You can mark the end of the chase by pressing
Chase.
You can store up to 64 steps in the chase. If you try to enter more, the chase will end
automatically.
If you want to abandon the chase, press Head, Colour or Gobo. The unit will ask
if you are sure you want to abandon it.
Storing speed, crossfade and sound mode
Once you have set the end of the chase, the controller will display
Set speed and Xfade
[Save]/[Cancel]
The controller will play back the chase you have just programmed.
If you want, you can set the default speed of the chase using the Speed slider, the
default crossfade time between steps using the Value slider, and whether the chase
will be sound triggered by pressing the Sound button. Press Save when all the
parameters are set. When you recall the chase, the default speed, crossfade and
sound trigger settings will be set automatically (you can then change them using the
controls if you want).