User Guide

Scene
Page 29
7.3 Scene setup
This function allows you to perform certain special operations on scenes, such as
erasing and copying. It also allows you to set up the scene crossfade mode. You select
the Scene Setup mode by holding down Scene for about 2 seconds.
Note: You won’t be able to select this option if the controller is in ‘Playback
Only’ mode.
Scene Setup
1-Erase scene
There are 6 possible actions which are displayed one after the other. You can:
1. erase an individual scene
2. erase a bank of scenes
3. copy one bank of scenes to another bank
4. set up the scene crossfade mode
5. set up the exclude channels mode
6. tell the unit to swap between scenes and chases rather than adding them
Press the number key of the option you want to select (you don’t have to wait for it
to be displayed).
1: Erase scene
This option allows you to erase an individual scene. You select the scene to erase
exactly as if you were recalling it. You can change bank by pressing the Bank button.
The controller will check you really want to erase it before wiping the memory for
that scene. (You don’t need to erase the scene if all you want to do is change it - you
can just overwrite the old scene).
2: Erase whole bank
This option erases a complete bank of 16 scenes. You select the bank of scenes to
erase exactly as if you were selecting a bank of scenes to recall. You can swap
between banks 1-16 and 17-24 by pressing the Bank button. The controller will
check you really want to erase the bank before wiping the memory for every scene in
the bank.
3: Copy a bank
This option allows you to copy an entire bank of scenes to another bank. You might
want to do this if you are ‘tidying up’ the storage of scenes on the controller.
The controller displays