User Guide

Scene
Page 26
7. Scene
When you have positioned all the heads to give an effect you want to keep, you can
save it as a
Scene
. You can then recall the scene at any time, or make it part of a
sequence (a
Chase
).
The controller can store up to 384 scenes, as 24 banks of 16 scenes. The memory has
a backup battery so that it will remember the scene indefinitely, even while turned
off. The controller has another 128 scenes which are pre-programmed, which you can
also use in your chases.
7.1 Saving scenes
Press Save, then Scene. The unit will display
Save as which scene?
Current bank:01
Some of the lights above the number buttons may come on to show you which scenes
in this bank have already been programmed. If the light is lit, that scene is
programmed.
Note: You can’t save scenes if the controller is set to playback only
mode.
Choose the scene number to save by pressing one of the number buttons. If you
choose a blank scene, the controller will save the scene straight away. If you choose a
scene that is already programmed, the controller will say
Scene already used
OK to overwrite?
Press Save (Yes) if it’s OK to overwrite the scene, or Cancel (No) if not. You can
choose another scene to write to if you decide you don’t want to overwrite that one.
Note: If you change a scene that is used in a chase, the new scene will be
automatically used in the chase in place of the old one.