Instructions

-7-

(Fig. 5)

Fig. 4)

(1.) Connect the jack connector of the charging cable to the charging

case (see Fig. 4) then connect the USB connector to a computer

or power supply adapter (Fig. 5).

The green LED indicates readiness. Place the batteries in the

charging case (ATTENTION: pay attention to polarity!).

The LED lights red during charging and changes to green when

the process is complete. The charging time for empty batteries

is approx. 2 hours.

(2.) Remove the battery retaining clips on

the vehicle to remove the batteries

(Fig.6)

(4.) Re-attach the battery retaining clips

to the vehicle (Fig. 8)

(3.) Equip the vehicle with the two batteries (Fig. 7)

(ATTENTION: pay attention to polarity!)

(Fig. 7)

(Fig. 8)

(Fig. 6)

3.7V

3. CHARGING AND INSTALATION OF THE RECHARGABLE BATTERIES

4. CHARGING CRADLE / BATTERIES / NOTES & INSTRUCTIONS

(1.) To prevent "overcharging" of the lithium batteries, the charging cas has a

protective function that prevents this. To preserve the performance of the

batteries, they should not be connected to the power supply with the

charging case for more than 24 hours.

(2.) The speed controller has a deep discharge protection function. This

function prevents damage to the battery. When this function is activated,

the vehicle stops and the speed controller in the vehicle ﬂashes red.

ATTENTION: Make sure that you switch off the vehicle after operation!

Otherwise the battery will be deeply discharged and damaged.

(3.) The cruise control has an overheat protection function. If the vehicle

overheats, this function is activated and the vehicle stops for 3-6 seconds.

You can continue driving the car after this time, but we advise to switch

off and cool down for a few minutes.

3.7V