User Manual

www.abrites.com
14
2021
Abrites Programmer User Manual
4. Connect the BDM adapter to the ECU using a ribbon cable. Warning: incorrect wiring may cause per-
manent damage to the adapter and/or the ECU.
5. Connect the BDM adapter(ZN073) to ABProg(ZN045).
6. Connect the ABProg(ZN045) to AVDI.
7. Connect AVDI to PC.
8. Power on AVDI.
Ensure orange LED on BDM adapter is ON
9. Power on the ECU – it should immediately enter Debug mode.
▯▯ Ensure green LED on BDM adapter is ON
10. Launch the Abrites programming software
11. Select the desired ECU memory from the software menu
12. Select desired operation (read/erase/program). Note: If you want to program the ECU, the selected
memory must first be erased
13. When finished, exit the user application
14. Power off the ECU
15. Power off AVDI and disconnect BDM adapter from target ECU
IMPORTANT NOTE: Do not write anything in the first 8 bytes of the MPC processor shadow rows, unless
you are completely certain in what you do. The shadow rows contain censoring information, and fiddling
with it may lead to locking out the processor without possibility for unlocking.