User Manual

www.abrites.com
9
2021
Abrites Diagnostics for Tesla User Manual
When connecting to a Tesla vehicle it is extremely important to adhere to the following steps in order to
avoid possible damage to the vehicle and your AVDI and PC.
Here is a list with the steps you MUST take before beginning work on a Tesla Model 3.
These must be completed before you connect the CB014 cable (part of the required ZN072 cable set).
1. Disconnect any charging cable
2. On the touchscreen, power off the climate control system, and wait at least 30 seconds for the climate
control system to completely shut down
3. Make sure the vehicle is in Park
4. Fully lower all door windows to avoid glass shatter and door lockout conditions
5. Open the LH and RH rear doors, and then pass a shop towel halfway through each door striker to pre-
vent the latch from securing
6. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace)
7. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace)
8. On the touchscreen, touch Controls > Safety & Security >Vehicle Power > Power Off
Caution: Do not proceed until the climate control system has been powered off for at least 30 seconds.
Do not disconnect 12V power while the climate control system is operational