User Manual

www.abrites.com
18
2021
Abrites Diagnostics for Tesla User Manual
Note: Whenever doing the key learning, make sure to follow all the steps to make the proper connection
as described in chapter 3 - “Using the Abrites diagnostics for Tesla”.
The software will open the next window which consists of 4-5 steps that are to be followed in order to
program one or more spare keys:
1. Press the lock button on all keys you want to keep and verify that they are shown as “Active”
2. Move a key to be programmed to within 30cm of the center console LF coil (near the cup holders)
3. Press and hold the front and rear trunk buttons simultaneously for 5 seconds and then release them
Important: Do not hold the buttons for more than 5 seconds!
4. Wait until the key is programmed - its status should change from “Programming” to “Active”
Repeat steps 2-4 to program each new key or to retry programming if one of the keys does not change
from “Programming” to “Active”.