Installation Guide

Step 3: Grouting and Final Cleaning: Before applying grouts make sure that the adhesive is set and firm
and the tiles are clean. Non-sanded grout is the recommend grout to use for mosaic sheets due to small
grout joints. Never use sanded grout on polished glass mosaics this will scratch the material. Never use
Epoxy grouts for the glass mosaic tiles, unless specified by the manufacturer.
Using grout float apply the grout on the tiles. Use vertical and horizontal stroke to spread the grout.
Apply a little pressure to make sure that all the joints are well filled.
While the grout is still fresh, stroke diagonally the long edge of the grout float to remove excess grout
and then wipe it with wet sponge to clean.
Once the grout is set and dry and if there is still residue use nylon brush to clean and then apply grout
sealer according to manufacturers instructions.
****Cutting Mosaics Using Wet Saw: When cutting mosaic on a wet saw, put a tile or a piece of hard
plastic down on the cutting tray. This is necessary to keep the mosaic from falling in the wide opening on
the blade channel tray to be able to make a good straight cut.