User guide

14
Using: accessories
Elbow attachment
Cotton cloth
To connect or remove the elbow attachment, twist the
elbow joint so that is faces downwards (the triangle lip
should be exposed above the floor brush – diagram A.)
Remove or fit the elbow attachment.
When fitting, turn 180° till the elbow attachment
represents diagram B.
The floor brush is now fully assembled.
The floor brush is suitable for the cleaning of large
washable wall and floor areas.
The floor brush can be used with or without the cotton
cloth: Sensitive surfaces, i.e. wood (sealed), laminates
(sealed) etc. should be used with the cloth.
To fit the cotton cloth, place the floor brush on the cloth
and pull the cloth under the clips on both sides.
The cleaning effect of a floor cloth can be improved by turning and changing the
cloth regularly.
To clean very dirty areas, move the floor brush over the surface slowly in order
to increase the cleaning action of the steam.
NOTE: Do not use on unsealed floors, soft plastics, or wooden furniture.
Extension tubes
Depending on the task at hand, you can fit one, two or three extension tubes.
Push the extension tube into the connection nozzle as far as it will go until you
hear it click into place. Then, attach the floor brush with elbow attachment.