User guide

11
Using your steam cleaner
Operating the steam cleaner
Before you plug the appliance in, check the water tank is full.
If it is not, refer to page 9.
Plug the mains plug into a socket and turn the cleaner
on by pressing the on/off button.
The red power indicator light will illuminate.
If the light does not illuminate, refer to page 18 for
problem solving.
The steam cleaner should take approximately 5
minutes to heat up to steam temperature.
This will be indicated by the following:
1. The steam indicator will illuminate green,
2. The safety cap (red pin) will go up.
The steam cleaner is now ready to use.
The green steam indicator light will cycle-on an
off during operation to show the cleaner is
maintaining the correct temperature.
Note:
A full water tank should provide approximately 20-25 minutes of use.
There may be an initial few drops of water ejected.
Steam time can vary according to volume and temperature of water in
the tank. Turn off the tank when not in use or apply safety lock.
1
2