User guide

Using: Filling the water tank

Re-filling the water tank

After approximately 5 minutes, when the unit

has cooled sufficiently, the red pin on the

safety cap will release to allow for removal.

This is a pressure release valve.

You can speed up the cooling time if you

release the steam pressure by pressing the

steam trigger. Make sure the steam is released

in a safe area, i.e. a sink.

Read the note below before re-following the

filling instructions.

Refit the safety cap, twisting it clockwise and

tightening.

Note:

It is recommended to empty the water tank before every refill.

This will prevent issues including overfilling and build up of scale.

Be careful not to overfill the water tank, leave a space at the top.

Overfilling may cause the cleaner to leak.

If the cap will not open after allowing 5 to 10 minutes to cool, push

down the red pin in to the safety cap.

After doing so you can unscrew the safety cap and re-follow the

filling instructions.