User's Guide

*Note: It takes about 1 minute for VDP to connect to Wi-Fi after power on. Before the Wi-Fi
connection is established, the Red LED may flash momentarily.!
2.4 Equipment Required!
The following equipment is required to use OSC: !
•
"A router supporting 2.4 GHz Wi-Fi network. The OSC should be connected to this
router with access to internet and the Abode mobile app. !
•
"An iPhone or Android smartphone#
Android version requirement: Android 5.1 or above. iPhone version requirement: iOS 9
or above. !
•
"If planning to use the OSC with your existing alarm system, an Abode security system
alarm panel is required – the panel must be registered a valid Abode user account.#
If planning to use the OSC as a standalone device, no Abode security system device is
required. #
2.5 Hardware Installation!
Step 1. Installation height is recommenced to be at least 4.5 feet (1.4 meters) from the ground
in both doorbell and security camera configurations. Before you begin installation for doorbell
mode, identify the doorbell circuit breaker and turn OFF main power to that circuit. !
Step 2. Remove Camera Body and mounts from package. Determine which mount will be
used. !
For AC-Powered (Doorbell) Setup:!
Loosen the two screws on the back of the Doorbell Mount. Connect hardwired 8-24V AC
doorbell wires to the inputs on the mount and rescue screws. Mount Doorbell Mount to exterior
of the house on door frame or siding using the included mounting screws. Use the included
wall anchors if installing on stone or masonry. Install OSC Camera Body to the Doorbell mount
by rotating the device 90 degrees to lock into place. Secure bottom security lock screw. !
Doorbell compatibility— the OSC is compatible with 8-24V AC-powered electronic and
mechanical doorbell chimes operating on a two-wire system. The camera is not compatible
with wireless doorbells.!