USB ADSL Modem Quick Installation Guide Doc. No.
REGULATORY STATEMENTS Part15, Class B This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interface, and 2. This device must accept any interface received, including interface that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Table of Contents HARDWARE INSTALLATION ........................ 1 Precaution ...................................................... 1 SOFTWARE INSTALLATION ......................... 2 Windows 98/98SE....................................... 2 Windows ME............................................... 5 Windows 2000............................................. 7 Windows XP .............................................
HARDWARE INSTALLATION Precaution Before the installation, make sure the USB port exists in your computer and is enabled. Go to My Computer Æ Control Panel Æ System. Open the Device Manager tab, check if the Universal Serial Bus controller device is found. 1. 2. 3. 4. You can connect this modem without powering down your PC. Connect the USB connector on the modem to the USB port of your PC. Connect the phone line to the phone jack on your modem. Windows will detect the new hardware automatically.
SOFTWARE INSTALLATION As you perform the installation, have your Windows disk at hand. You may need this disk to refresh or replace some Windows software. Also, make sure you have the existing Telephone Network Service and an ISP (Internet Service Provider) offered you ADSL service. After the device has been connected to your computer, Windows will detect the new hardware automatically. Windows 98/98SE 1. Click Next. 2. Select the Recommended option, and then click Next.
3. Insert the supplied CD into the CD-ROM drive. Click Specify a location then click Browse to provide the appropriate path (e.g. E:\Lan). Click Next. 4. Click Next. 5. Click Finish.
-4-
Windows ME 1. Select Automatic search for a better driver (Recommended), and then click Next. 2. Insert the supplied CD into the CD-ROM drive. 3. Click Finish.
-6-
Windows 2000 1. Click Next. 2. Select Search for a suitable driver for my device (recommended), and then click Next. 3. Insert the supplied CD into the CD-ROM drive. Select CD-ROM then click Next.
4. In “Driver Files Search Results”, click Next. 5. Windows is installing drivers for your new hardware.
6. The window may display a warning message, just ignore this message and click Yes to continue. 7. Click Finish to complete the installation.
Windows XP 1. Select Search for a suitable driver for my device (recommended), and then click Next. 2. The window may display a warning message, just ignore this message and click Continue Anyway to continue. 3. Windows is installing drivers for your new hardware.
4. Click Finish to complete the installation.
檔名: UAM700(QIG) 目錄: \\Nas\rd-2\Eleen\Sharing\Manual\English\xDSL\ADSL\UAM700 範本: C:\Documents and Settings\brenda\Application Data\Microsoft\Templates\Normal.