6-Port Fast Ethernet Switch User’s Guide M73-APO07-310
FCC REGULATORY STATEMENTS Part15, Class B This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interface, and 2. This device must accept any interface received, including interface that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
INTRODUCTION The 16-Port Fast Ethernet 10/100Mbps N-Way Switch provides you a flexible, reliable, and affordable solution of the Ethernet network. It comes with sixteen 10BASE-T /100BASE-TX ports. The 16-Port Fast Ethernet 10/100Mbps N-Way Switch is able to operate in both half and full-duplex modes. Each port delivers up to 200Mbps throughput in full duplex mode.
PARTS NAMES AND FUNCTIONS Front Panel: LED Indicators Status LED Color Solid Flashing Power Green Power is on.
HARDWARE INSTALLATION The switch is considered as a “plug and play” network device and requires no special setup procedures. Connect the power cord and cables correctly and you are ready to go. Switch installation 1. Put the switch on the appropriate location. When you install the switch, there are two things needed to be considered: Location: Your switch should be located in a place that is central to your home/office space and allows all computers and networked devices connected to your switch.
SPECIFICATION IEEE 802.3 10Base-T Ethernet Standards IEEE 802.3u 100Base-TX Fast Ethernet IEEE802.3x Flow Control Protocol CSMA/CD Ports Sixteen 10/100Mbps RJ-45 ports support auto-MDI/MDIX Switching Scheme Store-and-Forward Flow control Cabling type Speed per port MAC Address LED indicators Full Duplex: IEEE802.
