User's Manual

Chapter 3: Configuration

the value you set.

Warning: Enabling RTS Threshold will cause redundant network overhead

that could negatively affect the throughput performance instead of providing

a remedy.

This value should remain at its default setting of 2347. Should you

encounter inconsistent data flow, only minor modifications of this value are

recommended.

Beacon Interval

Beacon Interval is the amount of time between beacon transmissions.

Before a station enters power save mode, the station needs the beacon

interval to know when to wake up to receive the beacon. Range 20-1024 ms,

default is 100.

Preamble Type

A preamble is a signal used in wireless environment to synchronize the

transmitting timing including Synchronization and Start frame delimiter.

You can select Long or Short for the preamble type.

IAPP

Select Enabled or Disabled to execute this function.

Protection

Select Enabled or Disabled to execute the security function.

Aggregation

Select Enabled or Disabled to execute this function.

Short GI

Select Enabled or Disabled to execute this function.

WLAN Partition

Select Enabled or Disabled to execute this function.

RF Output Power

Select the transmitting power rate 100%, 70%, 50%, 35%, 15%.

Site Survey

Refresh

Check this button to refresh all the Site Survey list.

Connect

Under the Wireless ISP mode and select a site that you would like to

communicate, and then click the Connect button.