User's Manual

Chapter 2: About Operation Modes
33
MAC Address
MAC Address: Enter the Wireless BSSID (MAC) 12 characters of the wireless
AP that you want to connect with. To check your wireless router’s MAC
address, please go to Status > Wireless Configuration to find your BSSID
(Wireless MAC address.)
Data Rate
Select the data rate form the pull-down list.
Comment
Enter a description for the device.
Apply
Changes
After completing the settings on this page, click Apply changes button to save
the settings.
Reset
Click Reset to restore to default values.
Set Security
Enable the WDS function and then click Set Security button to set up the WDS
security.
Encryption: Select the encryption type None, WEP 64 bits, WEP 128 bits,
and WPA2(AES) from the pull-down menu.
WEP Key Format: For WEP 64 bits and WEP 128 bits encryption type, the
selection of WEP Key Format are Hex and ASCII.
WEP Key: If select Hex if you are using hexadecimal numbers (0-9, or A-F).
Select ASCII if you are using ASCII characters (case-sensitive).
 Hexadecimal (WEP 64 bits): 10 Hex characters (0~9, a~f).
 Hexadecimal (WEP 128 bits): 26 Hex characters (0~9, a~f).
 ASCII (WEP 64 bits): 5 ASCII characters (case-sensitive).
 ASCII (WEP 128 bits): 13 ASCII characters (case-sensitive).
Pre-Shared Key Format: The Pre-shared Key Format will be enabled when
WPA (TKIP) and WPA2 (AES) encryption be selected. There are two formats
for choice to set the Pre-shared key, Passphrase and Hex (64 characters). If
Hex is selected, users will have to enter a 64 characters string. For easier
configuration, the Passphrase (at least 8 characters) format is recommended.
Pre-Shared Key: Pre-Shared-Key serves as a password. Users may key in 8 to
63 characters string to set the passwords or leave it blank, in which the 802.1x
Authentication will be ac
t
ivated. Make sure the same
p
assword is used on