User's Manual

25
Threshold
Router often transmit large files in wireless network, you can enter new
Fragment Threshold value to split the packet. The value can be set from
256 to 2346. (The default value is 2346.)
RTS Threshold
RTS Threshold is a mechanism implemented to prevent the “Hidden
Node” problem. If the “Hidden Node” problem is an issue, please specify
the packet size. The RTS mechanism will be activated if the data size
exceeds the value you set. (The default value is 2347.)
Warning: Enabling RTS Threshold will cause redundant network
overhead that could negatively affect the throughput performance instead
of providing a remedy.
This value should remain at its default setting of 2347. Should you
encounter inconsistent data flow, only minor modifications of this value
are recommended.
Short Preamble
Select Disable or Enable this function. (Default setting is Disable.) A
preamble is a signal used in wireless environment to synchronize the
transmitting timing including Synchronization and Start frame delimiter.
Short Slot
Select Disable or Enable this function. (Default short slot setting is
Enable.)
Tx Burst
Check the box to enable the Tx Burst function. (Default Tx Burst setting
is Enable.)
Pkt_Aggregate
Select Disable or Enable this function. (Default setting is Enable.)
Wi-Fi Multimedia
WMM Capable
WMM Power Save is a set of features for Wi-Fi networks that help
conserve battery power in small devices such as phones, PDAs, and
audio players. The certification for both access points and client devices
uses mechanisms from the recently ratified IEEE 802.11e standard, and
is an enhancement of legacy 802.11 power save. WMM Power Save
helps pave the way for rapid proliferation of Wi-Fi technology into
devices dependent on battery power.
Select Disable or Enable to use or stop Wi-Fi Multimedia function.
(Default setting is Enable.)
APSD Capable
Automatic Power Save Delivery is a more efficient power management
method than legacy 802.11 Power Save Polling. Most newer 802.11
station already support a power management mechanism similar to
APSD. APSD is very useful for a VoIP phone, as data rates are roughly
the same in both directions. Whenever Voice data are sent to the Access
Point, the Access Point is triggered to send the buffered Voice data in
the other direction. After that the Voice over IP phone enters doze state
until next Voice data have to be sent to the Access Point.
Select Disable or Enable this function. (Default setting is Disable.)
DLS Capable
Direct Link Setup, this function will be enabled under the connection
with AP which must support the DLS function. Direct Link Setup allows
direct STA-to-STA frame transfer within a BSS (Basic Service Set).
This is designed for consumer use, where STA-to-STA transfer is more
commonly used.
Select Disable or Enable this function. (Default setting is Disable.)