User's Manual

Destination

The network address of the destination LAN segment. When a packet with

destination IP address that matches to this field, it will route to the device

set in the Route Gateway field.

Range

Select Host or Net from the pull-down menu.

Gateway

Enter the Gateway IP address in the field.

Interface

You can select to use LAN, WAN or Custom as the physical interface

from where the packets will be sent.

Comment

Enter note or remark here.

Dynamic Routing

Settings

Select Disable or Enable form pull-dowm list to use the RIP function.

Apply

After completing the settings on this page, click Apply button to save the

settings.

Reset

Click to discard current setting.

QoS

Quality of Service

Select Disable or Enable from the pull-down menu. (Default setting is

Disable.)

Upload Bandwidth

Select User defined to enter the upload transmitting bandwidth bits/sec

in the blank or select the upload bandwidth from pull-down list.

Download

Bandwidth

Select User defined to enter the download transmitting bandwidth

bits/sec in the blank or select the download bandwidth from pull-down

list.