User's Manual

Chapter 1: Introduction
5
Bottom Switch
Reset button and switch bar
Reset
Keep on pressing the Reset button more than 3 seconds, the
Wireless Router will set all setting back to factory default values.
Switch
User need to MANUALLY switch the bar into the mode preferred,
Router, AP or Client m
Mode, then the device will reboot
automatically into the mode selected.
Side Panel
Ethernet and power ports
Ethernet
When the mode be set to AP or Client modes, use standard LAN
cables (RJ45 connectors) to connect your PCs to this port. If
required, any port can be connected to another hub. Any LAN port
will automatically function as an "Uplink" port when necessary.
When the mode be set to Router mode, connect the ADSL or
Cable Modem here with RJ45 cable. If your modem came with a
cable, use the supplied cable, otherwise, use a standard LAN
cable (RJ45 connectors).
Power (5V)
Connect the supplied power adapter here.