User's Manual

Chapter 1: Introduction
4
WPS button
WPS
Press the physical WPS button on the Wireless Router once, or go to
enable the WPS function via web configuration (Go to Wireless >
WPS page), then the LED will start to flash. Please make a
connection with other WPS supported device within 2 minutes.
LED Behavior
LED Printed Color Behavior Indication
OFF Power off
ON Power on
POWER PWR
Green
Blinking Power saving mode starting
ON
Press reset button two seconds the
LED will on, keep on pressing more
than 3-5 seconds, the LED will start
to flash.
System SYS
Green
Blinking System CPU is busy
OFF WLAN function off
ON WLAN link / active
Wireless
LAN
WLAN
Green
Blinking WLAN traffic transmitting
OFF WPS off
ON WPS active and connected
WPS WPS
Green
Blinking
WPS is enabled to make a
connection
OFF No Ethernet cable connecting
ON Ethernet cable connected
Ethernet Ethernet
Green
Blinking Receiving/ sending data